Edge Architecture
Clarke St
Clonakilty, West Cork,
P85 KV91
Ireland   [View Map]

Tel: 023 8833800
Email: info@edgearchitecture.ie
Contact Us

Residential developmentEdge Architecture follow the design principles of Passivhaus standards with WALLTITE®

A cluster of residential buildings in a rural location is providing warm and energy efficient living space designed to meet the demanding requirements of the Passivhaus standard. Consisting of both new build and the conversion of a stone-walled barn, the development has used Walltite spray foam insulation to meet both thermal insulation and airtightness requirements throughout the structures.

The old barn building had solid stone walls: to get the required U-value 0.26W/m2K  a 75mm layer of Walltite was sprayed directly onto the interior wall surface, forming a seamless finish that is not only thermally efficient but is also both airtight and watertight. The Walltite layer was then covered with plasterboard for the interior finish.

The new build structures, on the other hand, were constructed of two leaves of concrete blocks with a 200 mm cavity held with insulating wall ties. This cavity was filled with Walltite CV 100 injection grade – a variation of the spray foam product  that is designed to be injected into cavity walls. The result was a U-value of 0.12W/m2K.

Edge Architecture, project designers, wanted all the buildings to follow the design principles of Passivhaus standards.   This requires not only extremely efficient thermal insulation but also the highest airtightness standard.    Walltite, being spray applied, is a highly reliable method of ensuring airtightness as any detailing is easily accommodated and jointing between insulation on the walls and roof is also completely reliable. The buildings for this project had a target airtightness of 1m3/hr/m2  @ 50Pa.

This project was a first experience of Walltite for both the architect and the energy consultant and both were impressed by the solution it offered. Eric Davidson from Reinco, Renewables and Insulation Consultancy observed: “It’s a neat and practical solution and particularly good in eliminating thermal bridging at joints”.

Eddie Burgess at Edge Architecture can see the advantages of the product: “It absolutely does what we wanted it to do. It was also quick to install and caused us no problems on site.  We will be specifying the product again.”

Project data

Project: Residential development, Cork, Eire
Client: Owner/occupier
Specifier: Edge Architecture
Spray Foam Contractor: Advanced Insulation
Scope of Project: Barn conversion and new build
Year Completed: 2012
Products Used: WALLTITE and WALLTITE CV 100 injection grade foam insulation


Download Walllite Case Study